Replacing a Serpentine Belt – EricTheCarGuy

Replacing a Serpentine Belt – EricTheCarGuy I’ve had more than one request for this, the other day I had one come in and was happy to make the video for it. This is a fairly easy one compared to some that I have had to deal with, just work smart and have the right tools and you will be fine. Remember the longer the tool the better the leverage and that you should check to make sure you have the correct belt before you try and install it. – Click below and Stay Dirty Visit me at EricTheCarGuy.com ericthecarguy.com Visit EricTheCarGuy Forum www.ericthecarguy.com Visit my Facebook Page: www.facebook.com – Stay dirtyDue to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole

24 thoughts on “Replacing a Serpentine Belt – EricTheCarGuy

  1. hey boss my name is STEVEN. I noticed oil leaking out of the crank shaft. Is there a oil seal on it. im knew to this

  2. I done everything but when i cut my car on the belt move off my alternator just a little and it didn’t do that before it was changed.

  3. This is great, but still looking for the release of the tension pulley. 2001 Dodge Stratus DOHC, 2.4L. I know where the pulley is located, but not the release.

  4. Ok that was A good one! Now why dont you have video on what happens when you drive with out a serpentine belt? What is the resuts to your motor?

  5. Hell noooo!!!! you shouldn’t hear any squeeling or smell any kind of smoke!!!!!! Your Mechanic is an IDIOT!!!!!

  6. Hey ERIC!!! is it normal for the belt to be smoking and a burning rubber smell when it operates? after you install a new belt. my mechanic says it does that at first. im skeptical and if my car fucks up im sueing his ass

  7. Is there a chance you could demonstrate this in a van (1992 chevy g20 to be specific) but any van would do. I am guessing you have to do it from underneath. I can’t seem to get to what I need to get to without removing a bunch of stuff. But, thank you, this has been a great help in understanding the process. I see a lot of videos on auto repair, but it is very hard to find videos dealing with vans. Thanks. =)

  8. You will might save hundreds on your auto insurance policy as long as youre a low-mile car owner. Learn about the ideas to saving bucks available at the following online site.
    FreeAutoInsuranceSecrets.com

  9. Eric – Thanks for your great videos. This one saved me $45 and took only 10 minutes to do.

  10. mr. eric, it has been observed that while carrying your work , u , explain each and everything very nicely, compared to others, awesome.. master…………….. sunil ghorpade from mumbai, india

  11. I’ve got a 2005 Honda Accord that has a intermittent chirp. I’ve replace the serpentine belt and no change. Replaced the Belt tensioner with pulley and no change. when its cold its fine but once the car warms up i get the chirp. What could it be? Turning on the ac makes it worse.

  12. we all know that we should make sure of the size of the belt
    (hermesbeltusa com <– Hermes H Belt Store)

  13. very nice video Eric i just wondered how would i know that the belt has the right tension?

  14. i have a 1998 toyota camry 2.2l when i’m in 3rd gear and accelerate up a hill i get a whiney-screeching kind of noise (Not a/c i know what that sounds like) and it doesnt go away until the car downshifts to accelerate. Have any idea what that could be? Sounds like a belt but i’m not sure.

  15. hi do you know how to change the serpentine belt on a peugeot 207 , it seems not to have a pulley

Napsat komentář k mrjuan22 Zrušit odpověď na komentář

Vaše emailová adresa nebude zveřejněna. Vyžadované informace jsou označeny *

*

Můžete používat následující HTML značky a atributy: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>